SB
 
Scale Setup
Step 1 -
Select the Units and select "Change Unit" to save.
Unit
Step 2 -
Enter your Operator ID and the Instrument ID. (these may be left blank).
Operator ID
Instrument ID

Step 3 -
Enter the total capacity of the scale.
(Total capacity = sum of load cell capacities less the dead load).
Scale Capacity

Enter the decimal point to set the resolution you want to display. The instrument can not display more than 100,000 divisions.
Decimal Point

Enter the graduation size to set the increment you want to display. The base graduation size is typically the scale capacity divided by 10,000.
Grads

Enter the motion tolerance for the scale. Typically set at 3 times the graduation size.
Motion Tolerance

Step 4 -
Save Your Parameters
Once you have saved your parameters, you are done with this section. Return to the Main Wizard Page
Previous Page
Back

Home - Calibration - Diagnostics - Monitor - Setup - Wizard - HI 6800 Series Online Support Site

Hardy Process Solutions
San Diego, California, USA
Tel. +1 (858) 278-2900 ▪ (800) 821-5831
Fax +1 (858) 278-6700
www.hardysolutions.com ▪ hardyinfo@hardysolutions.com
hardysupport@hardysolutions.com

homecalibrationdiagnosticsMonitorindexWizardhardy